Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Error - Cloning Win7 Pro, 32 bit to WD MyPassport Drive
#1
WinUSB Support,

I am using the WinToUSB (2.0, January 2015 Build) version that supports cloning a hard drive to an external USB drive.

Here is my configuration
External USB Drive; WD MyPassport Ultra 0830. Formatted NTFS
Source Computer;
• DELL Latitude E5540
• Windows 7 Professional, 32 bit

During the setup phase of WinToUSB I select the following options;
• Hard Drive; it displays the correct operating system and hard drive characteristics
• Destination Drive; Disk1: WD MyPassport 0830

After the application re-boots and executes the WinToUSB program it issues a dialog (Cloning,…please wait…)
However, I immediately get an error message; Specified disk not found. (0x0005003501220000)

NOTE:  if the USB drive does not have a volume on it; I get an error in the configuration setup (above). Setting a volume on the external drive gets me past that.

I was able to successfully clone a hard drive to the same model of USB drive on a DELL Latitude 6420.

When it mentions “specified” drive; is that the source or the destination drive?

Any ideas on what might be going on?  

Thanks,

Rich
Reply


Messages In This Thread
Error - Cloning Win7 Pro, 32 bit to WD MyPassport Drive - by rfronek - 04-10-2015, 02:50 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)