Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to enable features ...
#4
(08-23-2015, 12:35 AM)Ratte Wrote: It´s a Windows7SP1 x64 Professional USB-stick.

Is it possible to use a backup from usb-windows (win7sp1x64) for the internal hdd?
What are the differences between a normal installation and the win2usb-installation?
(BCD-settings and drive identifiers are not the problem)

The most important difference is the registry keys.


Please follow the steps below to convert the WinToUSB drive to a local installation drive.
1. Boot into the WinToUSB drive.
2. Run regedit.exe as administrator.
3. Go to "HKEY_LOCAL_MACHINE\SYSTEM\ControlSet001\Control\PnP" and set the value "PollBootPartitionTimeout" to 0.
4. Go to "HKEY_LOCAL_MACHINE\system\ControlSet001\Control" and set the value "BootDriverFlags" to 0.
5. Turn off the computer.
6. Connect the hard disk drive to a internal hard disk controller, then you can boot from it.
Reply


Messages In This Thread
How to enable features ... - by Ratte - 08-21-2015, 05:26 AM
RE: How to enable features ... - by admin - 08-21-2015, 09:55 PM
RE: How to enable features ... - by Ratte - 08-23-2015, 12:35 AM
RE: How to enable features ... - by admin - 08-23-2015, 11:43 PM
RE: How to enable features ... - by vagner - 08-24-2015, 07:50 AM
RE: How to enable features ... - by admin - 08-24-2015, 10:36 PM
RE: How to enable features ... - by vagner - 08-25-2015, 02:51 AM
RE: How to enable features ... - by admin - 08-25-2015, 09:00 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)