Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Screen Resolution
#3
(05-13-2016, 09:03 PM)admin Wrote:
(05-13-2016, 06:14 AM)wharris128 Wrote: I have created the USB Boot disk with Windows 10.  It starts booting then comes up with error about needing to change the screen resolution.  It says out of Range Signal cannot display this video mode.  Change computer display input to 1680x1050.  Is there a way to adjust the resolution of the build?

Thank you,

Wade

Do you mean that you have successfully created a Windows To Go drive but Windows 10 is unable to boot?

Yes, I get the start up screen with the MS Logo and the spinning dots, then the screen goes blank and a message about changing the computer display input to 1680x1050 comes up.  I can press shift+ the windows button then enter and the system will restart.  That sort of implies that it's actually setting at the login screen.
Reply


Messages In This Thread
Screen Resolution - wharris128 - 05-13-2016, 06:14 AM
RE: Screen Resolution - admin - 05-13-2016, 09:03 PM
RE: Screen Resolution - wharris128 - 05-13-2016, 11:02 PM
RE: Screen Resolution - admin - 05-13-2016, 11:12 PM
RE: Screen Resolution - wharris128 - 05-13-2016, 11:28 PM
RE: Screen Resolution - admin - 05-13-2016, 11:34 PM
RE: Screen Resolution - wharris128 - 05-13-2016, 11:36 PM
RE: Screen Resolution - admin - 05-14-2016, 12:04 AM
RE: Screen Resolution - wharris128 - 05-14-2016, 12:14 AM
RE: Screen Resolution - admin - 05-14-2016, 12:21 AM
RE: Screen Resolution - wharris128 - 05-14-2016, 12:28 AM
RE: Screen Resolution - admin - 05-14-2016, 12:39 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)