Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
It does not boot and remains in a loop
#1
I have installed the Windows 8.1 on the usb following the instructions but when I reboot the computer and start by the usb, it remains in a loop showing the logo of windows:

[Image: iHBjlUQm.jpg]

I'm using the last version of Wintousb and I have proved with usb 3.0 and 2.0, but it does not work
Reply
#2
The common USB flash drives are very slow. It takes a long time to install and run Windows from a common USB flash drive, highly recommend using a USB hard disk, a Windows To Go Certified Drives or a SanDisk Extreme CZ80 USB 3.0 Flash Drive to create Windows To Go workspace.
Plese make sure to use the VHD installation mode when installing to a USB flash driver.
Free Data Recovery & Windows To Go Creator & UEFI Boot Manager & Windows Deployment Tool
Hasleo Software (formerly called EasyUEFI Development Team)
Reply
#3
(02-23-2015, 01:17 PM)admin Wrote: The common USB flash drives are very slow. It takes a long time to install and run Windows from a common USB flash drive, highly recommend using a USB hard disk, a Windows To Go Certified Drives or a SanDisk Extreme CZ80 USB 3.0 Flash Drive to create Windows To Go workspace.
Plese make sure to use the VHD installation mode when installing to a USB flash driver.

They are so expensive for me. Is It normal to be during three hours in the same loop? If you grant me that after X hours I will have the screen in other state I have no inconvenient to let the computer all the night working in it.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)