Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
WintoUSB win7 and usb3.0
#1
I have been successful in installing Windows 7 Ultimate 64bit on128gb usb3.0 flash drive. The problem happens once I attempt to run it.. The splash screen comes up and the drivers begin to install, once I get to 100% I get an error. Due to hardware on this computer setup cannot be completed. It basically reboots and starts the process over again with the same result.. I know that Windows 7 has issues with USB 3.0 so I have tried installing and running in a USB2.0 slot using the USB 3.0 flash drive with no luck. I even tried using my Windows 8.1 OS but I get a spinning wheel on boot that doesn't go away it seems. Any help is appreciated.
Reply
#2
Please try again using a USB hard disk.
Reply
#3
Enabling USB3.0 - Windows 7 Pro x64
- Installed Win7 Win2USB on a 32Gb USB-Stick on a normal way

Upgrading from USB2.0 to USB3.0 Drivers:
- booting from usb2.0 usb-port
- installing usb3.0 Drivers (Intel baytrail)
- no reboot - manually deinstall Drivers in device Manager (dont select delete Driver)
- reboot (using usb2.0 port) in Windows safe mode !!!
- execute device Manager and search for new Hardware
- usb3.0 Drivers (still present from preview installationprocess) will be installed again
- reboot

Next normal start is with working usb3.0 Drivers .... booting from USB3.0 port is working, too.

Important: sometimes this process failed, try again.
Important 2: USB3.0 sticks must be "fast" enough to avoid stopping .. min. 20mb/s

My System:
http://www.acer.co.uk/ac/en/GB/content/m....MRSEK.001
Acer Aspire E11 notebook
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)