Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Can't select destination partition
(06-26-2015, 02:57 AM)rcolbert71 Wrote:
(06-25-2015, 10:05 PM)admin Wrote: Thank you for reporting this problem.
Which version of WinToUSB you are using? Can WinToUSB recognize the file system of these two partitions correctly?
Please send the "user.log" to me, it is located in the bin folder under the installation directory.

Was this resolved as I have a 1tb seagate that I am trying to load win 7 to and I cannot get the next button to ungrey either.
I have formatted the drive, set it up both MBR and GPT, fat and NTFS, etc..

It lists in the drop down of both disk amamagement and also the list for WinToUSB.
I have included a snip it.

Actually I found the issue.
I needed to make the allocation a little bigger on the part of the drive in order to complete the load.

Messages In This Thread
RE: Can't select destination partition - rcolbert71 - 06-26-2015, 03:12 AM

Forum Jump:

Users browsing this thread: 1 Guest(s)