Cannot get either Pre or Post commands to work

[APC]

I've recently had to move from Macrium Reflect due to the psmounterex.sys issue. I was pleased to discover Hasleo Backup as it appeared to do all that I needed. However I am having problems getting either Pre or Post-Commands to work. I have created a small test backup with a post command to run a simple test .bat file to pop-up a text message. I can see that the batch file is triggered, but nothing happens and no backup is created. Hasleo Backup then hangs and Cancel does not work. No log file is created.

I also wanted to use a Pre-Command to switch on an external HDD before backing up to it, but have read that this is not possible at the moment?

[admin]

Hello,

Please give this version a try:
https://www.easyuefi.com/backup-software...260615.exe

If it still fails, please refer to the image below to save the log file and send it to us.


Best regards,